![]() Since we don't want to actually play any tapes anymore, and I don't want any signals from the tape heads to interfere with the audio signal, I disconnected both tape head wires from the board. As you’ve noted, Denon does not provide a dedicated tape loop input/output that would allow for easy connection of a cassette or CD recorder. Thus, our aux cable is connected to the circuit between the pre-amp and amplifier for speaker output. These are the pre-amp output pins for each channel, as I found on the data sheet. HDMI cables carry up to 32 channels of digital audio. The Akai tape selector will be connected to an Audio Research LS26 preamplifier Monitor input/output switch. Then, we will solder the inner (signal) wire from our aux cable to pins 5 & 20. I am in need of RCA-RCA audio cables to hook a Nakamichi CR-7A cassette deck, an Akai GX-747 dbx reel to reel deck and a Technics RS-1500 reel to reel deck to a vintage Akai tape selector (DS-5). We will solder the outer wire from each channel of our aux cable to a ground pin on the chip. Youve got the right idea stripping the RCA ends, but you will need to attach them to the input of the amplifier, rather than directly to the speakers. I found the datasheet for the chip online by googling TA8189N. One might be able to hook one a component into the source in and another into the tape in and run them by switching between on the EQ, which is connected to the amplifier through the source out. On our board, the pre-amp is a little black chip labeled Toshiba TA8189N. If you want to hook up more than one component in between components, you will need some RCA piggyback cables. The easiest way to do this is to solder the aux cable to the pre-amp output. We want to connect our aux cable to the circuit between the pre-amp and the amplifier. The signal from the tape player is fed through a pre-amp to strengthen the signal before it goes into the regular amplifier. We're planning on replacing the tape function of the stereo with our aux cable. This can be achieved either by running a cable from your Hi-Fi, or by using a Phono Preamp. To record vinyl albums (or 78s) you will need to hook up your record deck to your sound card or other input device. The tricky part here is figuring out where to connect the cable to the circuit board. First things first the simple setup: If youre hooking your vintage turntable to a stereo receiver or amplifier that has jacks on the back marked PHONO. Hooking up your Computers Speakers Testing your Setup Using a Laptop Recording on a Modern Mac Connecting a Turntable to your. I cut the cable to about 2 ft and stripped the ends of the wire. I used a 3.5mm stereo to RCA cable from Monoprice, but anything with a 3.5mm audio jack on the end will work.
0 Comments
Leave a Reply. |